User’s ManualVersion 2.8
Last Updated: November 7, 2024
Contributors:
- Dr. Steve Maas (steve.maasutah.edu)
- Dr. Gerard Ateshian (ateshiancolumbia.edu)
- Dr. Jeff Weiss (jeff.weissutah.edu)
- Michael Herron (michaelrossherrongmail.com)
Contact Address:
Weiss Lab, University of Utah https://mrl.sci.utah.edu
Ateshian Lab, Columbia University https://mbl.me.columbia.edu
FEBio: https://febio.org
Development of the FEBio project is supported in part by a grant from the U.S. National Institutes of Health (R01GM083925).
Table of contents
- Chapter 1 Introduction
- Chapter 2 Getting Started
- Chapter 3 The FEBioStudio Environment
- Chapter 4 Creating, Loading, and Saving Models
- Chapter 5 Creating and Editing Geometry
- Chapter 6 Materials
- Chapter 7 Boundary Conditions and Loads
- Chapter 8 Contact and Constraints
- Chapter 9 Rigid Bodies
- Chapter 10 Defining Analysis Steps
- Chapter 11 Configuring Output
- Chapter 12 Running FEBio from FEBioStudio
- Chapter 13 The Post Environment
- Chapter 14 Saving Graphics
- Chapter 15 The Post Panel
- Chapter 16 Post Processing
- Chapter 17 Visualizing 3D Image Data
- Appendix A Mesh Import Formats
- Appendix B Standard Data Fields